Inserting Or Replacing Sd Cards - Honeywell Touchpoint Plus Wireless User Manual

Issue 1 04/19
3020M5044_1

4.6.2 Inserting or Replacing SD Cards

SD Cards must be unlocked to allow read/write. They must be formatted by TPPLW only, and they should be
used for TPPLW data only. Stored data can be transferred or copied to a PC via a Card Reader and the card
reused, but care must be taken not to overwrite previously transferred data files held on the PC. A reliable backup
system should be used if data retention is important.
Transferred data may be imported into spreadsheets or DBs for ease of handling / printing, but you should
check the number of spreadsheet lines available as some software may be limited to 65000 entries per sheet.
Note: Incorrectly removing or replacing an SD card may result in data loss or corruption.
Opening the enclosure may expose live electrical circuits. Touching exposed terminals or wires may cause
death or serious injury. Always turn off and isolate the system before opening the door. Do not switch back on
To Insert or Replace an SD Card:
1) Log in as Admin or Service.
2) Touch Menu>Maintenance>SD Card>Eject>
3) Touch Close>Menu>Maintenance>Power-off>Yes
4) Switch off and Isolate Power.
5) Open the access door and locate the SD card slot (Refer to Fig. 9).
6) Insert or replace the card in the SD card slot.
7) Close the access door, restart the system and wait for it to stabilise.
8) Check the SD Card status by touching on either the SD Card or Power Icons:
9) If the SD Card is new, full or has a fault, log in as Admin or Service.
10) Touch Menu>Maintenance>SD Card>Format>Yes
11) Close the window and log out when finished.
12) Re-check the SD Card status by touching on either the SD Card or Power Icons again.
Formatting the SD card will erase all existing data, and TPPLW has no selective delete or file recovery function.
Note: The SD Card must remain inserted during normal system operation as the on-board flash
memory is limited to a few minutes of events. When the card is full it should either be replaced or
space freed up to avoid data loss.
User Guide
until the door is reclosed and secured. Do not operate TPPLW with the door insecure.
Take alternative site safety precautions while power is off.
WARNING
Caution
25
Touchpoint Plus Wireless
User Guide