Routine Testing; Exercising The Relays; Exercising Audio/Visual Alarm - Honeywell Touchpoint Plus Wireless User Manual

Issue 1 04/19
3020M5044_1

6.2 Routine Testing

6.2.1 Exercising the Relays

Relay output channels can be tested by forcing the relays to an active state:
1) Login as Service or higher level
2) Select the Menu > System test > Force Relay
3) Select the Relay module to be tested, and toggle it off and on for the specific Relay channel
4) Check the relay out contact using a voltage meter
5) Repeat steps 3 and 4 for all relay output channels

6.2.2 Exercising Audio/Visual Alarm

Audio/visual alarm can be tested by forcing signal out:
1) Login as Service or higher level
6) 2) Select the Menu > System test > Dedicated Alarm Contacts
3) Toggle it off and on for each outputs
4) Check the voltage level using a voltage meter
5) Check the alarm outputs are visible / audible and turn them off when satisfied.
6) Touch Finish when the tests are completed and all selections will automatically turn off.
Maintenance and Scheduled Testing
When any of the test modes is active, the System Failure relay will activate to indicate
that the safety function of the system is not operating.
Ensure that the system is returned to normal operation once testing is complete.
Ensure that the system is returned to normal operation once testing is complete.
CAUTION
CAUTION
Caution
39
Touchpoint Plus Wireless
User Guide