Construction; Touchpoint Plus Wireless Packaging; Packaging Components For Return To Manufacturer; Disposal (Weee Directive) - Honeywell Touchpoint Plus Wireless User Manual

Issue 1 04/19
3020M5044_1

3.1.9 Construction

The system cabinets are constructed from PC ABS plastic with a secured quick release front access door
panel.
The Controller door panel holds a touch sensitive colour LCD with a membrane cover over additional buttons,
LEDs and an audible warning horn.
Inside the Controller cabinet is a Switched-Mode Power Supply (SMPS) providing a nominal DC 24 V output,
an optional Lithium-ion backup battery, a Main Module, a mA Input Module, one Relay Modules, protection
fuses, and the control and user interface electronics.
Both cabinets contain a common Earth (ground) rail that must be bonded to Protective Earth (Ground) through
an isolation switch that does not disconnect the Earth line.

3.1.10 Touchpoint Plus Wireless Packaging


Touchpoint Plus Wireless outer packaging is made from cardboard. Facilities for recycling are widely
available.

Touchpoint Plus Wireless inner packaging is made from Stratocell
foam. The foam can be recycled into new Stratocell


3.1.11 Packaging Components for Return to Manufacturer

Honeywell is unable to accept any consignment that does not conform to the European Classification,
Labelling and Packaging (CLP) Regulations (EC) 1272/2008.
Consult your distributor, supplier, or the manufacturer if you require further advice.

3.1.12 Disposal (WEEE Directive)

The system contains Lithium batteries and a number of homogenous hazardous materials. These should be
disposed of carefully in accordance with the WEEE Directive and local laws and guidelines. Under no
circumstances can they be disposed of as domestic waste.
System General Description
17
®
, Low-Density Polyethylene (LDPE)
®
where such recycling facilities exist.
Touchpoint Plus Wireless
User Guide