Ble Hid - Data Transfer - ProGlove Mark 2 User Manual

BLE HID - DATA TRANSFER

PROBLEM
Barcode data is not transferred.
MARK 2 lights up green after the
data transfer, but no barcode data
is shown on the end device.
Different barcode data is trans-
ferred.
MARK 2 flashes red 3 times,
3 negative beeps are heard and a
long vibration is felt.
38
CAUSE
MARK 2 is not connected to the
end device.
MARK 2 is out of range of the end
device.
(Maximum range is < 33ft.)
The keyboard layout of the end
device is set with a different
language.
MARK 2 cannot connect with the
end device.
SOLUTION
1. Scan the pairing barcode.
2. Lights up blue twice briefly while MARK 2 is
connecting and after a successful connection.
Bring MARK 2 closer to the end device and

scan the pairing barcode.
Adjust the keyboard layout of the configuration

tool to the keyboard layout of the end device.
In the configuration tool
(config.proglove.de)
"Device settings - BLE-HID keyboard layout," ad-
just the language.
1. Check whether the range between MARK 2 and
end device is < 10 m. If not, get closer.
2. Disconnect the connection between the end
device and MARK 2 and reconnect
"Step 6: Disconnect MARK 2" and
4)
"Step 4: Connect MARK 2."
3. Scan the pairing barcode again.
4. Scan barcode again.
under
(see 19 Chapter