Access Point Ones - ProGlove Mark 2 User Manual

ACCESS POINT ONE S
OVERVIEW
The Access Point One S receives the scanned barcode
data from MARK 2 via 868/915 MHz. This barcode data
is transmitted to the end device via USB cable or RS232
cable. In the USB HID mode, the Access Point One S simu-
lates a computer keyboard. A standard connection is em-
ulated in the USB CDC mode. In order to use the USB CDC
mode,
(config.proglove.de)
mode" the device must be set to "USB CDC" in the configu-
ration tool.
More detailed information about the conversion can
be found in chapter 5 "Configuration tool."
A RS232 cable establishes a serial connection between
Access Point One S and the end device.
Pairing
Barcode
LED
Cable release
opening
RJ45 socket
10
under "Device settings - Output
Label with serial number
TECHNICAL DATA
MECHANICAL PROPERTIES:
Dimensions: ........................... 138 x 64 x 33mm
Weight: ................................... 100g
ELECTRONIC PROPERTIES:
Power supply of Access
Point One S via USB cable: ...
Power supply of Access
Point One S via RS232
cable: .....................................
RADIO TRANSMISSION:
Encryption: ............................. AES-128
Transmission range: ............. up to 30m
ENVIRONMENTAL
CONDITIONS:
Protection against dust and
water: ..................................... IP22
Working temperature: ........... -23°F to +122°F
5 VDC (0.5A)
via host computer
12 VDC (1A)
via power supply PG12-10P55
within a building