Connection With Usb Cable In Usb Cdc Mode; Connection With Rs232 Cable - ProGlove Mark 2 User Manual

CONNECTION WITH USB CABLE IN USB CDC MODE:

1. Connect the USB cable to the
end device.
2. Plug the other end of the USB
cable into the RJ45 socket of
the Access Point One S. A clear
clicking sound confirms the
correct fastening.
3. In the configuration tool
(config.proglove.de)
settings - USB output mode,"
select USB CDC.
information about this can be found
in chapter 5 "Configuration tool."
4. Connect with the COM port
on the end device.
RESULT
The LED of the Access Point One S lights up green.
The Access Point One S is connected to the end device.

CONNECTION WITH RS232 CABLE:

under "Device
More detailed
RESULT
The LED of the Access Point One S lights up green.
The Access Point One S is connected to the end device.
1. Connect the RS232 with the
end device. Connect the power supply
to the RS232 and into an external
power source.
2. Plug the other end of the cable into
the RJ45 socket of the Access Point
One S. A clear clicking sound con-
firms the correct fastening.
3. Check which baud rate must be
set. The baud rate is set to 115,200 as
a standard. At a different baud rate,
this is to be set in the configuration
tool .
(config.proglove.de) More detailed
information about this can be found in
chapter 5 "Configuration tool".
4. Select the COM port on the end
device and set the appropriate baud
rate.
868
(915)
MHz
17