Setup Of Mark 2 System; Connection With Usb Cable In Usb Hid Mode - ProGlove Mark 2 User Manual

Hide thumbs Also See for Mark 2:
Table of Contents

Advertisement

SETUP OF MARK 2 SYSTEM

1
STEP: CHARGE MARK 2
ST
CAUTION
Only use MARK 2 in a dry Charging Station S and
only touch with dry hands!
This may otherwise lead to the Charging Station S
not functioning properly.
RESULT
MARK 2 pulses red and charges in the Charging
Station S.
NOTE
The LEDs pulse red while in charging mode. When
the battery is fully charged, the LEDs pulse green. It
takes about 2 hours to charge MARK 2.
16
The pins face down.
Insert MARK 2
in the Charging Station S.
2
STEP: CONNECT THE ACCESS
ND
POINT ONE S
(868/915 MHZ)
CAUTION
Only touch the Access Point One S with dry hands!
This may otherwise lead to the Access Point One S system not
functioning properly.
NOTE
The following steps are only needed when connecting via
868/915 MHz.
For a connection via BLE HID; see p. 18

CONNECTION WITH USB CABLE IN USB HID MODE:

1. Connect the USB cable with the
end device.
2. Plug the other end of the USB
cable into the RJ45 socket of the
Access Point One S.
A clear clicking sound confirms
the correct fastening.
RESULT
The LED of the Access Point One S lights up green. The
Access Point One S is connected to the end device.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mark 2

Table of Contents