ProGlove Mark 2 User Manual page 36

Hide thumbs Also See for Mark 2:
Table of Contents

Advertisement

PROBLEM
The crosshairs light up, but no bar-
codes are scanned.
The crosshairs light up, but the bar-
codes are hard to scan.
36
CAUSE
The barcode label cannot be read.
The barcode type cannot be read.
The barcode length cannot be read.
Scanner glass is dirty.
The barcode label is difficult to read.
Scanner glass is dirty.
Scanning distance is not optimally
used.
SOLUTION
Create new barcode label.
Check whether the barcode type in the
configuration tool
(config.proglove.de)
abled under "Barcode settings."
Check whether the barcode length in the
configuration tool
(config.proglove.de)
abled under "Barcode settings."
Clean the scanner glass with a cotton
swab.
To enhance the scanning performance,
make the following settings in the configu-
ration tool
(config.proglove.de)
settings: "Fuzzy 1D processing: ON
Clean the scanner glass with a cotton
swab.
Position MARK 2 closer or further away
from the barcode label and scan.
For standard range: 10 - 80 cm
For mid range: 30 - 150 cm.
is en-
is en-
under "Device

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mark 2

Table of Contents