Table of Contents
Advertisement
2.3
Non-compliance with Safety
Instructions
Non-compliance
with
jeopardise the safety of personnel, the environment
and the machine itself. Non-compliance with these
safety instructions will also lead to forfeiture of any
and all rights to claims for damages.
In particular, non-compliance can, for example,
result in:
-
failure of important machine/unit functions
-
failure of prescribed servicing and maintenance
practices
-
hazard to persons by electrical, mechanical,
chemical and thermal effects
-
hazard to the environment due to leakage of
hazardous substances.
2.4
Safety Awareness
It is imperative to comply with the safety instructions
contained in this manual, the relevant national
health and safety regulations and the operator's
own internal work, operation and safety regulations.
2.5
Safety Instructions for the Operator /
User
-
Any hot or cold components that could pose a
hazard must be equipped with a guard by the
operator.
-
Guards which are fitted to prevent accidental
contact with moving parts (e.g. coupling) must
not be removed whilst the machine is operating.
-
Leakages (e.g. at the shaft seal) of hazardous
media handled (e.g. explosive, toxic, hot) must
be contained so as to avoid any danger to
persons and the environment. Pertinent legal
provisions must be adhered to.
-
Electrical hazards must be eliminated. (In this
respect refer to the relevant safety regulations
applicable to different countries and/or the local
energy supply companies.)
safety
instructions
can
2.6
Safety Instructions for Servicing,
Inspection and Installation Work
The operator is responsible for ensuring that all
servicing, inspection and installation work be
performed
by
personnel who are thoroughly familiar with the
manual.
Work on the machine must be carried out only
during
standstill.
described in the manual for taking the machine out
of service must be adhered to without fail.
Pumps or pump units handling media injurious to
health must be decontaminated.
Immediately following completion of the work, all
safety-relevant and protective devices must be re-
installed and/or re-activated.
Please observe all instructions set out in the
chapter 6.1 on "Commissioning" before returning
the machine to service.
2.7
Unauthorised Modification and
Manufacture of Spare Parts
Modifications or alterations of the machine are only
permitted after consultation with the manufacturer.
Original spare parts and accessories authorised by
the manufacturer ensure safety. The use of other
parts can invalidate any liability of the manufacturer
for consequential damage.
2.8
Impermissible Modes of Operation
The warranty relating to the operating reliability and
safety of the pump/unit supplied is only valid if the
machine is used in accordance with its designated
use and if all operating instructions described in
chapter 1 have been followed. The limits stated in
the data sheet must not be exceeded under any
circumstances.
Page 5 of 24
authorised,
qualified
The
shutdown
RDLO
specialist
procedure
Hide quick links:
Advertisement
Table of Contents
