Perkins 1206A-E70TTA Operation And Maintenance Manual page 35

M0090743
Table 2
Shutdown
Warning Action Indi-
Lamp cator Lamp
On On
If any of the indicators will not illuminate during indicator check, the fault must be investigated immediately
If any Indicators stay illuminated or flash, the fault must be investigated immediately.
Off Off
On Solid Off
Flashing Off
Flashing On Engine Shutdown Level 3 warning
Indicator Lamp Table
Lamp State Description of the Indication
Lamp Check When the keyswitch is moved to the ON po-
sition, the lamps come on for 2 seconds and
the lamps will then go off.
No Faults With the engine in operation, there are no
active warnings, diagnostic codes, or event
codes.
Warning Level 1 warning
As soon as possible the fault should be investigated.
Warning Level 2 warning
Stop the engine. Investigate the code.
If both the warning lamp and the shutdown
lamp are in operation, this issue indicates
one of the following conditions.
1. One or more of the shutdown values for
the engine protection strategy has been
exceeded.
2. A serious active diagnostic code has
been detected.
If install, the audible warning will sound.
After a short time period, the engine may
shut down.
Operation Section
Engine Indicators
Engine Status
The keyswitch is in the ON position but the en-
gine has not yet been cranked.
The engine is operating with no detected
faults.
The engine is operating normally but there is
one or more faults with the electronic manage-
ment system for the engine.
The engine continues to be operated, but the
level of importance of the warning has
increased.
Depending on the particular fault and the se-
verity the engine may be de-rated.
The engine could be damaged if continued to
be operated.
The engine is either shutdown or an engine
shutdown is imminent. One or more monitored
engine parameters have exceeded the limit for
an engine shutdown. This pattern of lamps can
be caused by the detection of a serious active
diagnostic code.
Contact your Perkins dealer or your Perkins
distributor.
35