Start Of Operation; Unpacking, Transport And Installation; Combination With The Neoserv; Connect And Switch On - gbo Medizintechnik Duodynator Instructions For Use Manual

8

2 Start of operation

2.1 Unpacking, transport and installation

After unpacking check all components for external integrity.
The unit may be placed on any flat surface. It must not be placed on the floor. Keep a
wall distance of at least 20 cm. The device should neither be placed in front of radiators
nor should it be covered by pillows or blankets while in operation. The device is not
made for outdoor operation.
Duodynator and Neoserv meet the requirements for electrical safety according to
EN 60601-1 and are both devices of protection class I. Within the scope of the
Medical Devices Directive (MDD), Class IIa is assigned for the Duodynator. The
Neoserv is an accessory for Duodynator. The combination Duodynator-Neoserv is
in Class IIa
Warning!
 The unit is not designed to be operated in places with the inherent
 If the patient and/or the patient cable is directly exposed to a radiator

2.2 Combination with the Neoserv

When the Neoserv is used as an accessory, Duodynator must be placed above the
Neoserv and screwed on the back. Do this, slide the Duodynator from behind the
retaining tab on the lid of Neoserv. Align both devices and screw the two devices on
the back of each other.
In the case of the combination with Neoserv the Duodynator is supplied with mains
voltage from Neoserv. Thus, a line input on Neoserv is enough to power both
devices.
A detailed pictorial instruction is supplied with the Neoserv.

2.3 Connect and switch on

The Duodynator and the combination Duodynator-Neoserv are designed for
connection to a supply voltage of 100 to 240 V and are automatically set to the
correct mains voltage.
Regardless of the supply voltage, the device is suited for power frequencies of 50 to
60 Hz.
 gbo Medizintechnik AG
Note for use in the clinical area:
risk of explosions. If it is used in dangerous areas of anesthesia
departments, the possibility of an explosion cannot be excluded.
of a medical device for high frequency heat therapy, damage of the
device or danger to the patient cannot be excluded. As a rule, a
clearance distance of 3 m is sufficient.
Duodynator
Version 1.2