Billy Goat BG1002 Operator Owner's Manual page 11

MAINTENANCE
17 17 17 17
17
Inspect machine for loose bolts before starting engine.
Maximum Vacuum: See Maximum Vacuum found in
Operation section on page 5. The debris Bag can be washed.
Lubrication: Using S.A.E. 30 weight oil or
equivalent. See maintenance schedule.
Chain: See DRIVE section below.
Lower Control Ends: Oil moving parts, such as
bail, and height control.
Grease: Wheels, Casters, and Rear Axle Bearings.
Tire air pressure: SP units only. Check at regular intervals &
maintain. Rear SP tires at 24 psi. (17 kPa).
DRIVE
17.3 SP MODELS ONLY
Chains and Belts are normal replaceable wear items. A new
chain should not be used on worn sprockets. Sprockets
should be replaced when replacing chains.
BELT ADJUSTMENT
As V-belt wears, adjustments may be required. Adjust belt by
tightening or by loosening clutch cable nut as required. See
figure 3 & 4. When replacing belt, see impeller removal on
page 10. See parts list for impeller bolt torque specifications.
DO NOT OVER ADJUST.
CHAIN LUBRICATION
With machine not running, oil chain using general S.A.E. 30
weight oil every 25 hours or as needed. Note: Be sure that
entire length of chain is properly oiled. Oiling only a few
positions in the chain rotation will not properly oil the chain.
CHAIN ADJUSTMENTS
1. Remove chain guard
2. Inspect chains and sprockets for wear, lubrication and
tension. Replace if badly worn or damaged.
CHAIN TENSION AND ALIGNMENT
3. Install new chain, locating keeper clip of chain connecting
link on inboard side of chain.
4. Reinstall bearing onto axle and assemble bearing
mounting screws. Leave screws only partially tightened.
5. Push bearings outward against each rear wheel, fully
spreading wheels to both ends of axle.
6. With bearings pressed fully outward against wheels,
keeping axle square with engine base, align and tension
chain, and slightly tighten front bearing screws first. Then
slightly tighten rear bearings. (Note: Tightening front of
bearings first, helps keep chain tight.)
7. Recheck chain alignment, tension and axle squareness. If
ok, fully tighten front and then rear bearing screws. Repeat
adjustment steps if necessary.
8. Check chain tension and roll wheels to be sure there are no
excessively tight areas in the chain. Readjust if necessary.
A slightly loose chain is better than an over tightened one.
9. Reinstall chain guard.
10. Reinstall spark plug wire.
Part No. 800012
continued
Page 11 of 12
Clutch
Cable
Adjustment
Clutch
Cable Nut Up to
tighten belt
Down to
loosen belt
75
70
75
Engaged Drive Position: Belt guides should clear
belt by 0.06" - 0.125" (1.5mm - 3.3mm)
36
Belt
Pulley
Turns
Freely
Neutral Position
Fig. 3
0.06 (1.5mm)
0.125 (3.3mm)
Fig. 4
Form No. F021402A
0.06 (1.5mm)
0.125 (3.3mm)