Siemens SINAMICS S120 Function Manual page 219

Table 5-3
Abbreviation
and symbol
CI
CO
Interconnecting signals using BICO technology
To interconnect two signals, a BICO input parameter (signal sink) must be
assigned to the required BICO output parameter (signal source).
The following information is required for connecting a binector/connector input to
a binector/connector output:
S Binectors: Parameter number, bit number, and drive object ID
S Connectors with no index: Parameter number and drive object ID
S Connectors with index: Parameter number, index, and drive object ID
Fig. 5-5
© Siemens AG, 2005. All rights reserved
SINAMICS S120 Function Manual, 06/05 Edition
Connectors
Name
Connector input
Connector input
(signal sink)
Connector output
Connector output
(signal source)
BO: Binector output
CO: Connector output
Signal source
BO
r0722.0
CO (without index)
r0036
CO (with index)
Index [0]
r0037
[1]
r0037
[2] r0037
[3] r0037
Interconnecting signals using BICO technology
Basic information about the drive system
BICO technology: interconnecting signals
Description
Can be interconnected to a connector out-
put as source.
The number of the connector output must
be entered as a parameter value.
Can be used as a source for a connector
input.
BI: Binector input
CI: Connector input
Signal sink
BI
pxxxx.y
722.0
CI
pxxxx.y
36
CI
pxxxx.y
37[2]
bico_1.vsd
5-219