Table of Contents
Advertisement
Assembly Instructions
Set up the board number on the board
Note that the number of the board slot as well as the board
number on the board must be set; this is essential for further
functioning of the internal I/O bus communication.
Insert the relevant jumpers in the suitable pin connector in order to
►
define the number on the board ( Fig.
=
jumper
board position
(slot no.)
Remove the cover plate of the respective slot (2 screws).
►
Insert the board with the side meant for the process connection in the
►
slot on the rear panel (blue plug for Ex boards, otherwise green plug,
Fig. 6-2).
Page 52 of 120
1
2
3
Fig. 6-5: Pin connector with jumper positions
Operating Instructions
6-5
and 6-6).
4
5
6
6
7
enCore FC
Advertisement
Table of Contents
