Key Lock - ProLights Z7SPOT User Manual

Z7SPOT
15
to communicate by pressing the sync button present on the same. Then connect any DMX console to wifi
unit for to open the communication with the Z7SPOT unit.
• To reset the unit press the MODE button until the display shows Wireless Reset, then press the ENTER
button.
• Use the UP/DOWN button until the display reads Yes, and then press the ENTER button.
• Press the MODE button to go back or to meet the waiting time to exit the setup menu.

3.20 KEY LOCK

Enter the Key Lock mode to select whether the access password is on or off.
• Press the button MODE so many times until show Key Lock and press the button ENTER to confirm.
• Use UP/DOWN button to select: ON or OFF.
• Press ENTER button to confirm the selection.
When the fixture is set as pass ON, after 30 seconds or turn on the fixture next time, the fixture will need
an access password to enter the display menu control.
NOTE - The factory access password is UP + DOWN + UP + DOWN (press ENTER to confirm the access).