Dimmer; Back Light; Fixture Information; White Balance - ProLights Z7SPOT User Manual

14

3.15 DIMMER

• To enter dimmer mode and choose to simulate different dimming curves, press the MODE button re-
peatedly until the display shows Dimmer Mode, then press the ENTER button.
• Press the button MODE repeatedly until Dimmer Mode shows, and press ENTER button to accept.
• Use the button UP/DOWN to select a dimmer curve Off - Dimmer1 - Dimmer2 - Dimmer3.
• Press ENTER button to confirm the selection.
• Press the MODE button to go back or to meet the waiting time to exit from the setup menu automati-
cally.

3.16 BACK LIGHT

• To activate backlight display press the button MODE so many times until shows Back Light, and press the
button ENTER to confirm.
• Press the button UP/DOWN to select On - 10s - 20s - 30s. Press ENTER button to confirm the selection.
• Press the MODE button to go back or to meet the waiting time to exit from the setup menu automati-
cally.

3.17 FIXTURE INFORMATION

1. Press the MODE button so many times until shows Information, and then press ENTER button.
2. Use UP/DOWN button to select: Fixture Hours - Version.
3. Press ENTER button to confirm the selection.
4. Press the MODE button to go back or to meet the waiting time to exit from the setup menu automati-
cally.
Fixture Hours
This option shows the user the amount of hours the Z7SPOT has been in use throughout its lifetime.
Select Fixture Hours.
Version
This option shows the user the software version currently installed in the unit. Select Version.

3.18 WHITE BALANCE

Enter the White balance to adjust the Red, Green, and Blue parameter to make different whites.
• Press the button MODE so many times until shows White Balance, and press the button ENTER to confirm.
• Select the color R, G, B through the buttons UP/DOWN, then press the button ENTER.
• Using UP/DOWN button, select the desired color value 125 - 255.
• Press ENTER button to continue to the next color R, G, B.
• Continue until the desired mix is obtained.
• Press the MODE button to go back or to meet the waiting time to exit the setup menu.

3.19 WIRELESS SETTING

• To set the wireless mode refer to the following guide:
• Press the MODE button until the display shows Wireless Setting, then press the ENTER button.
• Use the UP/DOWN button until the display reads Wireless Receive, and then press the ENTER button and
select the ON mode.
• Press the MODE button to go back or to meet the waiting time to exit the setup menu.
NOTE - After you complete these steps, you have to synchronize with any wifi unit with which you want
Z7SPOT