Advertisement
4
MACHINE LAYOUT
Shown below is the configuration using a franker stand as suggested on Page 2. Use of oth-
er equipment may differ to that shown below, but the position of the Franker Link in relation
to the franker and inserter will remain similar.
In practice, the various units may not be aligned exactly as shown. When operating, the top
edge of the envelope slides along the turn plate, and this should be aligned with the datum
edge of the franker. Several envelopes may need to be run through to establish the correct
position.
Franker Stand
Inserter
Height Adjustment
The Franker Link is positioned to match the output of the inserter with the input of the
franker. There are 3 adjustable feet underneath the franker link which may be turned in
or out to raise or lower the unit. They may be adjusted to tilt the unit so that the angle of
its top surface matches that of the input slope of the franking machine, with the adjoining
edges of the two units aligned. The table must be adjusted for height so that the top edge
of the franker link is approx. 60mm (2.5") below the nip of the output rollers of the mailer.
(Depending upon speed, stationery type etc., better results may be achieved by altering this
distance). The height adjustment range of the unit is approx. 30mm (1.25").
Mailer
100/140 Franker Link Unit Operator Manual
Franking Machine
Franker Link
Align angle of Franker Link
Unit with input slope of franker.
Page 6
Stand Extension
Franker Conveyor
Advertisement
