Samsung DW80M9 Series Service Manual page 45

Related
Item Symptoms
Parts
n1: Version Display
n2: Inspection Code
Display
n3: Smart Install
Auto
Mode Result Display
n4: Operation Cycle
Display
When holding the following keys, the version displays alternating with "n1":
- Normal Course Key: Sub PBA Version Display
- Heavy Course Key: Sub PBA Touch IC SW Version Display
- Delicate Course Key: Model Option Display
- Express (Quick) Key: Inverter PBA SW Version Display
- Rinse Key: WiFi Module Version Display
(Only for WiFi models; before receiving the version data, display "---"; display version if version information is received)
- Each time Normal (Europe: Eco) Key is pressed, the code on display changes in a loop starting from the last saved code :
C00 → C10 → C20 → C30 → C40 → C50 → C60 → C00 → ...
- Up to 7 inspection codes can be saved, any additional code overwrites the oldest code.
※ Inspection codes are saved according to [Dish Washer - Inspection Mode - Inspection Recall Mode].
1. Each time Heavy Key is pressed while inspection code is on display, the information about the condition which triggers the
inspection code displays in sequence.
ex : When C00 displays, it changes as follows: C00 → C01 → C02 → C03 → C04 → C05 →C06 → ...
When C10 displays, it changes as follows: C10 → C11 → C12 → C13 → C14 → C15 → C10 → ...
※ CX1: X indicates the order of inspection code on display.
C01: indicates the code ID which occurs most recently.
2. When the operation button is held for 7 seconds with the inspection code on display, it clears all the inspection data.
It determines based on the data saved in EEPROM.
- Smart Install Auto Mode is successfully completed: it is indicated by "OK"
- Smart Install Auto Mode is not successfully completed or not performed: it is indicated by "nG"
- The max. value is 9999 and it does not go any higher.
- When the finishing session is entered, Cycle Cnt increases unless Cancel & Drain has been enabled.
Description
Troubleshooting_43