Samsung DW80M9 Series Service Manual page 33

Part
Drain pump
Motor geared
(Vane motor)
Sensor-vane
Figure
Preparation:
•
1. Disconnect the wire connector.
2. Push the locking hook like the red box.
3. Turn the Drain pump completely to the direction of
4. Drag the Drain pump to the direction of yellow arrow.
Preparation :
•
•
1. Remove one screws through the window of Assy
2. Remove one screws through the hole of base which
3. Disconnect the wire connector.
4. Pull the motor geared out.
Preparation :
•
1. By releasing the hook, disassemble the sensor.
Description
Remove the Assy cover base.
- Refer to the "Assy cover base" disassembly
section to separate Assy cover base until step 2.
red arrow.
Remove the case gear.
- Refer to the "Case gear etc" disassembly section
to separate Assy cover base until step 3.
Remove the Assy cover base.
- Refer to the "Assy cover base" disassembly
section to separate Assy cover base until step 2.
cover base.
was under the cover gear.
Remove the Assy cover base.
- Refer to the "Assy cover base" disassembly section
to separate Assy cover base until step 2.
Disassembly and Reassembly _ 31