Samsung DW80M9 Series Service Manual page 23

Part
Assy guide water
Assy motor
holder
Figure
Housing
Cover nozzle
2
3
1
Description
Preparation:
• Disasssemble the Assy rail.
- Refer to the "Assy rail" disassembly section to
separate Assy rail.
1. Separate 3 screw shown with red arrow.
2. Lift up the front parts of Housing carefully like the
picture and be careful of the hook on the back side
of the Cover nozzle.
Caution
- Be careful not to lose the gear.
There are two gears in total.
▪ Gear Upper : Small, attached with Housing.
▪ Gear Lower : Big, inside the cover nozzle.
- Be careful not to break the Hook on rear.
1. Remove two (2) screw then open the plate back.
3. Insert needle nose pliers into the gap and press the
tab. Then rotate the assy motor holder up to remove.
4. Remove two (2) wire connectors.
Disassembly and Reassembly _ 21