Removing The Upper Rack; Preparation For Parts Replacement - Samsung DW80M9 Series Service Manual

3-2. PREPARATION FOR PARTS REPLACEMENT

1. Take out the residual water inside the product. (Drain the water by operating the drain pump)
2. Close the water supply valve.
3. Turn off the power. You must turn off the circuit breaker connected to the product.
4. Pull out the unit from the sink and lay it on the floor. Be careful of the drain hose when pulling out the unit.
Warning
Always turn off the electric power supply & water supply before servicing any electrical component, making ohmmeter
checks, or replacing any parts.
Caution
Before moving the unit, laying it down for service, or removing any parts for service be sure to drain as much of the water
from the unit as possible. Use a protective mat or towel to prevent damage to the floor or having any of the remaining
water spill on the floor.
All voltage checks should be made with a voltmeter having a full scale range of 250 volts or higher. After service is
completed, be sure all safety grounding circuits are complete, all electrical connections are secure, and all access
panels are in place.
Before servicing, make sure to remove all items from inside of the dishwasher, including the wash racks.

3-3. REMOVING THE UPPER RACK

Pull the upper rack towards the front and then remove it by lifting it up slightly and pulling it towards the front.
See the illustrations below.
Caution
While the upper rack is removable, it must be installed for the dishwasher to operate properly.
If you attempt to operate the dishwasher without the rack, noise will occur and the dishwasher will perform poorly.
.
Step 1
10 _ Disassembly and Reassembly
.
Step 2
.
Step 3