Samsung DW80M9 Series Service Manual page 14

Part
Door outer
12 _ Disassembly and Reassembly
Figure Description
Preparation:
• Make sure to disconnect the power.
• Remove the lower basket in the dishwasher.
• Cover the Assy sump with a towel to prevent
losing screws.
1. Open the door completely to prevent losing
screws.
Before removing the parts, place a cushioned
mat on the floor to prevent the parts from being
scratched.
2. Remove the 12 screws (short one 8 pieces, long
one 4 pieces) which holding the door outer and
control panel in place.
After removing screws, make sure to hold the door
outer using your hand. This will prevent the door
from closing suddenly and harming you.
Caution
Do not place the removed screws on the door
inner. They may fall into the sump assy.
3. Pull out the door outer carefully.
4. Separate wire connectors indicated by the red
arrows in the picture to the left and separate the
Wire from the Hook shown with red arrow.
- DW80M9960US/UG : 10 wire connectors
- DW80M9550US/UG : 8 wire connectors
5. Lay a mat on the floor to protect the Door and put
down the Assy door outer.