Devicenet Object Classes - Danfoss VLT DeviceNet MCA 104 Programming Manual

Parameter Access

5.3 DeviceNet Object Classes

5.3.1 Class ID 01h Identity Object
Class ID 01h identity object is a standard DeviceNet object for identification of the device (frequency converter). Set the
heartbeat interval in this object. The attributes supported for this class are listed in Table 5.3.
Attribute
1
5 5
2
3
4
5
6
7
10
Table 5.3 Class ID 0x01
5.3.2 Class ID 03h DeviceNet Object
Class ID 03h DeviceNet object is a standard DeviceNet object for configuration and status of the DeviceNet connection. The
attributes supported for this class are listed in Table 5.4.
Attribute
1
2
4
5
6
7
Table 5.4 Class ID 0x03
18
VLT
Access Name
Get Vendor
Get Device Type
Get Product Code
Get Revision
Get Status
Get Serial Number
Get Product Name
Get/Set Heartbeat
Interval
Access Name
Get/Set MAC ID
Get/Set Baud rate
Get BOC
Get Allocate
information
Get MAC ID switch
changed
Get Baud rate
switched from
last power-up
Danfoss A/S © 12/2015 All rights reserved.
®
DeviceNet MCA 104
Data type Minimum/
Maximum
USINT –
UNIT –
UNIT –
UNIT –
UNIT –
UDINT –
String –
USINT 0–255
Data type Minimum/
Maximum
USINT 0–63
USINT 0–2
– –
– –
BOOL 0–1
BOOL 0–1
Units Default Description
– 97 Danfoss Drives Vendor
code.
– 2 AD/DC Motor.
– 100 See chapter 3.2.1 EDS File.
– – Software version on FC
102, FC 202, or FC 300.
– –
– – From frequency
converter.
– – FC 100, FC 202, or FC
300.
s 0 Off.
Units Default Description
– 63 Node address.
– 0 0=125
1=250
2=500
– – Bus-off counter.
– – Only required if
predefined master/slave
is implemented.
– 0 The node address switch
has changed since the
last power-up/reset.
– 0 The baud rate switch has
changed since the last
power-up.
MG92F102