Rear - Sony UP-D72XRS Instructions For Use Manual

E G, g, F, f (Cursor control) buttons (12, 13, 14,
17)
Use these buttons to increase or decrease a value or
level shown on the menu, or to scroll up and down
through a menu.
F EXEC button (11, 17)
Press this button to carry out cleaning or cancel the
error status after solving the problem.
G
PRINT button (10)
Press this button to print the image data stored in
the memory of the printer again.
H ! POWER switch (10, 17)
Press to turn the printer on or off.
I EJECT TRAY button (9, 21)
Press this button to eject the paper tray.
J Paper output slot (9, 21)
Printed pages (or printouts) are ejected here.
K Paper tray (9, 21)
Load paper or film into this tray. Also, ejected
printed pages are accumulated on the cover of this
tray.
L Remaining paper confirmation window
You can confirm the amount of paper remaining in
the paper tray here.
M Maintenance door (17)
Open this door when cleaning the thermal head.
6
Location and Function of Parts and Controls

Rear

A PARALLEL DATA (IEEE1284) connector
(Amphenol 36-pin) (8)
Used to connect a computer and so on via the
parallel interface, using the parallel interface cable.
(not supplied)
B Special connector
Currently, this connector is not used. It is reserved
for future use.
C Cable stopper
Fixes the interface cable to prevent it from being
disconnected.
D Fan cover (18)
Ventilation holes are located under this fan cover
which is provided to prevent the printer from
overheating.
E
Equipotential ground terminal
Used to connect to the equipotential plug to bring
the various parts of a system to the same potential.
See "Important safeguards/notices for use in the
medical environments" on page 2.
F - AC IN connector (8)
Used to connect the unit to a wall outlet, using the
AC power cord.
Refer to "Warning on power connection" on page 3
and "Warning on power connection for medical
use" on page 3.