Rear - Sony UP-D70A Series Operating Instructions Manual

Rear

UP-D70A
1 PARALLE DATA IN (Amphenol 36-
pin) (10)
Used to connect a Windows computer via the
parallel interface, using the parallel interface
cable. (not supplied)
2 SCSI Connectors (11)
Used to connect a Windows or Macintosh
computer or another SCSI device, through the
SCSI cable. The other connector is loop-
through connector. If either of the two
connectors is not being used, set the
terminator of the DIP switch to ON.
(See "Setting the DIP Switch" on page 11.)
3 DIP switch (11)
Used to set the SCSI ID number and the built-
in terminator to ON or OFF.
(See "Setting the DIP Switch" on page 11.)
4 ⁄AC IN connector (12)
Used to connect to a wall outlet, using the AC
power cord supplied.
UP-D70A (with 6-digit serial
numbers)
7
Introduction