Rear - Sony UP-D70XR Instructions For Use Manual

Rear

1 PARALLE DATA IN (Amphenol
36-pin) (10)
Used to connect a Windows computer via the
parallel interface, using the parallel interface
cable. (not supplied)
2 SCSI connectors (Half pitch 50-pin)
(11)
Used to connect a Windows or Macintosh
computer or another SCSI device, through the
SCSI cable. The other connector is loop-
through connector. If either of the two
connectors is not being used, set the
terminator of the DIP switch to ON.
(See "Setting the DIP Switch" on page 11.)
3 Equipotential ground terminal 1
Used to connect to the equipotential plug to
bring the various parts of a system to the same
potential.
Refer to "Important safeguards/notices for use
in the medical environments" on page 2.
4 DIP switch (11)
Used to set the SCSI ID number and the built-
in terminator to ON or OFF.
(See "Setting the DIP Switch" on page 11.)
5 ⁄AC IN connector (12)
Used to connect to a wall outlet, using the AC
power cord supplied.
7
Introduction