Units Selection (For Aqt 200 Only) - Adam Equipment AQT Series Manual

"L-On" means auto backlight function is active.
"L-OFF" means this function is inactive, i.e. backlight is shut off.
• Turn off the power and then turn it on again to enter the normal
weighing mode.
7.3

UNITS SELECTION (FOR AQT 200 ONLY)

• Next press [Unit] to enter the units selection mode, the display will
show "On ct".
• Press [Tare] to select On or OFF.
On means this weighing unit is enabled,
OFF means this unit is disabled.
• Press [Unit] to go to the next weighing unit. The following weighing
units can be selected in sequence.
ct – oz – dwt – tL.H – tL.S – tL.T (Note: g is always activated)
• Turn the balance off and back to on again to return to normal
operation.
NOTE: It is recommended that the balance is used in a location with
sufficient light so that the backlight function can be turned off to
maximise the battery life.
© Adam Equipment Company 2005