Symbols, Abbreviations And Conventions - Danfoss VLT DriveMotor FCM 106 Design Manual

Introduction
•
PC-based Configuration Tool MCT 10, enables the
user to configure the frequency converter from a
Windows™ based PC environment.
•
Danfoss VLT® Energy Box software, for energy
calculation in HVAC applications.
•
Approvals.
Technical literature and approvals are available online at
www.danfoss.com/BusinessAreas/DrivesSolutions/Documen-
tations/Technical+Documentation.
Danfoss VLT® Energy Box software is available at
www.danfoss.com/BusinessAreas/DrivesSolutions, PC software
download area.
1.3 Symbols, Abbreviations and
Conventions
The following symbols are used in this manual.
NOTICE
Indicates highlighted information that should be
regarded with attention to avoid mistakes or operate
equipment at less than optimal performance.
* Indicates default setting
®
VLT DriveMotor FCP 106 and FCM 106 Design Guide
AC
AEO
AWG
AMA
°C
DC
EMC
ETR
f
M,N
FC
HO
IP
I
LIM
I
INV
I
M,N
I
VLT,MAX
I
VLT,N
LCP
N.A.
NO
P
M,N
PCB
PE
PELV
Regen
RPM
T
LIM
U
M,N
Table 1.1 Abbreviations
Conventions
Numbered lists indicate procedures.
Bullet lists indicate other information and description of
illustrations.
Italicised text indicates
•
•
•
•
MG03M102 - 08/2015
Alternating Current
Automatic Energy Optimization
American Wire Gauge
Automatic Motor Adaptation
Degrees Celsius
Direct Current
Electromagnetic Compatibility
Electronic Thermal Relay
Nominal Motor Frequency
Frequency Converter
High overload
Ingress Protection
Current Limit
Rated Inverter Output Current
Nominal Motor Current
The Maximum Output Current
The Rated Output Current Supplied
by the Frequency Converter
Local Control Panel
Not applicable
Normal overload
Nominal Motor Power
Printed Circuit Board
Protective earth
Protective Extra Low Voltage
Regenerative Terminals
Revolutions Per Minute
Torque Limit
Nominal Motor Voltage
cross reference
link
footnote
parameter name, parameter group name,
parameter option
1 1
5