Danfoss VLT DriveMotor FCM 106 Design Manual page 56

Specifications
Enclosure
Overload 1)
Typical shaft output [kW]
Typical shaft output [hp]
Max. cable cross-section in
terminals 2
(mains, motor)
2
[mm /AWG]
Output current
40 °C ambient temperature
Continuous
(3x380-440 V) [A]
6 6
Intermittent
(3x380-440 V) [A]
Continuous
(3x440-480 V) [A]
Intermittent
(3x440-480 V) [A]
Max. input current
Continuous
(3x380-440 V )[A]
Intermittent
(3x380-440 V) [A]
Continuous
(3x440-480 V) [A]
Intermittent
(3 x 440-480 V) [A]
Max. mains fuses
Table 6.12 Mains Supply 3x380-480 V AC Normal and High Overload: MH3 Enclosure
1) NO: Normal overload, 110% for 1 minute. HO: High overload, 160% for 1 minute
A frequency converter intended for HO requires a corresponding motor rating. For example, Table 6.12 shows that a 5.5 kW motor for HO requires
a P7K5 frequency converter.
2) Max. cable cross-section is the largest cable cross-section that can be attached to the terminals. Always observe national and local regulations.
54
®
VLT DriveMotor FCP 106 and FCM 106 Design Guide
MH3
P5K5 P7K5
NO HO NO
5.5 7.5
7.5 10
4/10 4/10
12 15.5
13.2 14.4 17.1
11 14
12.1 13.2 15.4
11 15
12 17 17
9.4 13
10 15 14
See chapter 6.9 Fuse and Circuit
Breaker Specifications
MG03M102 - 08/2015