Clutch Pedal; Continuously Variable Transaxle (Cvt) Fluid - Suzuki SWIFT Owner's Manual

INSPECTION AND MAINTENANCE

Clutch pedal

Fluid control clutch
EXAMPLE
MAX
MIN
Check the clutch pedal for smooth opera-
tion and clutch fluid level from time to time.
If clutch dragging is felt with the pedal fully
depressed, have the clutch inspected by
an authorized SUZUKI dealer. If the clutch
fluid level is near "MIN" line, fill it up to
"MAX" line with DOT3 or SAE J1703 brake
fluid.
7-21
Continuously Variable
Transaxle (CVT) fluid
Specified fluid
Use a CVT fluid SUZUKI CVT FLUID
GREEN-2.
Fluid level check
NOTICE
Driving with too much or too little
fluid can damage the transaxle.
You must check the fluid level with the CVT
fluid at normal operating temperature.
57RK086
To check the fluid level:
1) To warm up the CVT fluid, drive the
vehicle for more than 5 km (3 miles).
2) Then drive for ten more minutes.
NOTICE
Be sure to use the specified CVT
fluid. Using CVT fluid other than
SUZUKI CVT FLUID GREEN-2 may
damage the CVT of your vehicle.
NOTE:
Do not check the fluid level if you have just
driven the vehicle for a long time at high
speed, or if you have driven in city traffic in
hot weather. Wait until the fluid cools down
(about 30 minutes), or the fluid level indi-
cation will not be correct.
3) Park your vehicle on level ground.
4) Apply the parking brake and then start
the engine in "P" (Park). Let it idle for
two minutes and keep it running during
the fluid level check.
5) With your foot on the brake pedal,
move the gearshift lever through each
gear position, pausing for about three
seconds in each position. Then move it
back to "P" (Park) position.
WARNING
Be sure to depress the brake pedal
when moving the gearshift lever, or
the vehicle can move suddenly.
57RK0-14E