Suzuki SWIFT Owner's Manual page 127

If the master warning indicator light
blinks and the ignition modes cannot
be selected
Your keyless push start system remote con-
troller may not be sensed as being within the
interior workable area (refer to the related
explanation in this section). Try again after
checking that you have the remote controller
with you. If the ignition modes still cannot be
selected, the battery of the remote controller
may be discharged. To select an ignition
mode, you must then use the following
method:
EXAMPLE
(1)
(2)
52RM30020
1) Without depressing the brake pedal,
push the engine switch (1).
2) The master warning indicator light in
the instrument cluster blinks and the
message "PLACE KEY FOB
START SWITCH" appears in the infor-
mation display within about 10 sec-
onds. Touch the engine switch with
LOCK button side of remote controller
(2) for about 2 seconds.
NOTE:
• If you still cannot select the ignition
modes, there may be some problem with
the keyless push start system. Contact
an authorized SUZUKI dealer for an
inspection of the system.
• The immobilizer/keyless push start sys-
tem warning light will come on for about
5 seconds while the master warning indi-
cator light is blinking. In addition, the
information display in the instrument
cluster will show a message during this
time. Refer to "Information display" in
"BEFORE DRIVING" section for details.
• You may customize the system to cause
the interior buzzer to sound once for
warning that remote controller is out of
sensing range. To incorporate this cus-
tomization, please contact an authorized
SUZUKI dealer.
OPERATING YOUR VEHICLE
• If the battery of the remote controller is
becoming discharged, the correspond-
ON ing message will appear in the informa-
tion display when you press the engine
switch to change the ignition mode to
ON. Refer to "Information display" in
"BEFORE DRIVING" section for details.
For details on replacing the battery, refer
to "Keyless push start system remote
controller / keyless entry system trans-
mitter (if equipped)" in "BEFORE DRIV-
ING" section.
REMOTE CONTROLLER OUTSIDE
warning
When either of the conditions described
below is met, the system causes a
REMOTE CONTROLLER OUTSIDE warn-
ing by sounding the interior and exterior
buzzers. At the same time, the immobi-
lizer/keyless push start system warning
light comes on and the master warning
indicator light blinks.
• Any door is opened and then closed while
the remote controller is not inside the vehi-
cle and the engine is running or the igni-
tion mode has been changed to ACC or
ON by pressing the engine switch.
• The remote controller is not inside the
vehicle when you attempt to start the
engine after changing the ignition mode
to ACC or ON by pressing the engine
switch.
3-8
57RK0-14E