Suzuki SWIFT Owner's Manual page 140

OPERATING YOUR VEHICLE
For more details, refer to the explanation
below.
Automatically stopping the engine
Manual transaxle models
1) With the clutch pedal fully depressed,
stop the vehicle.
EXAMPLE
61MM701
2) While depressing the brake and clutch
pedal, place the gearshift lever in the
"N" (Neutral) position.
3-21
EXAMPLE
3) Release the clutch pedal.
The ENG A-STOP indicator light (green)
(1) in the instrument cluster will illuminate
and the engine will stop automatically.
NOTICE
The brake booster becomes inoperative
and the pedal effort will increase when
the engine is stopped automatically.
If the vehicle is moving, press down
the brake pedal harder than usual.
NOTE:
The ENG A-STOP system will not operate
and engine does not stop automatically
under the following conditions:
• The ENG A-STOP OFF switch is
pressed to deactivate the ENG A-STOP
system.
• The ENG A-STOP OFF light blinks.
• Engine coolant temperature is either low
or high.
• Vehicle battery performance is low.
• The temperature of the vehicle battery is
either low or high.
• Brake booster vacuum pressure is low.
• Depressing the accelerator pedal.
• During or after the ABS or ESP
is activated, and the vehicle is stopped.
• During the first period use, to initialize
the system.
(1)
• After the engine restarted automatically,
and the vehicle speed had not exceeded
approximately 6 km/h.
• When the engine is started with the hood
57RK104
open.
• When the vehicle is stopped after back-
ing up.
• The signal to prevent stopping the
engine is received from any electronic
control systems other than the ENG A-
STOP system.
®
system
57RK0-14E