Suzuki SWIFT Owner's Manual page 90

BEFORE DRIVING
Trip meter
The display (E) shows the trip meter.
The trip meter can be used to measure the
distance traveled on short trips or between
fuel stops.
You can use trip meter A or trip meter B
independently.
To reset the trip meter, push and hold the
trip meter selector knob (2) for a while.
NOTE:
The indicated maximum value of the trip
meter is 9999.9. When you run past the
maximum value, the indicated value will
return to 0.0.
Odometer
The display (F) shows the odometer.
The odometer records the total distance
the vehicle has been driven.
NOTICE
Keep track of your odometer reading
and check the maintenance sched-
ule regularly for required services.
Increased wear or damage to certain
parts can result from failure to per-
form required services at the proper
mileage intervals.
2-69
Eco-driving display
When you press the engine switch to
change the ignition mode to LOCK (OFF),
the following information appears for sev-
eral seconds on the information display.
EXAMPLE
(5)
(6)
(5) Idling stop time
The display shows the length (in
hours, minutes and seconds) of
engine stopping time by ENG A-
STOP system for one drive.
(6) Idling stop fuel saved
The display shows the amount (in mil-
liliters) of fuel conservation by the
ENG A-STOP system for one drive.
NOTE:
• You can change the setting so that the
Eco-driving display will not be displayed.
For details on the setting mode, refer to
"Setting mode" in this section.
• The total amount of fuel conservation by
the ENG A-STOP system and total idling
stop time can be displayed in the infor-
mation display when the ignition switch
is in "ON" position or the ignition mode is
ON.
57RK122
57RK0-14E