Suzuki SWIFT Owner's Manual page 151

Hide thumbs Also See for SWIFT:
Table of Contents

Advertisement

52RS30040
If the message shown in the above illustra-
tion appears on the information display,
there may be a problem with the ESP
system. Have your vehicle inspected by an
authorized SUZUKI dealer.
NOTE:
®
The ESP
system will not activate while
this message is displayed.
ABS warning light / brake system
warning light
See "Braking" in this section.
Hill hold control system
(if equipped)
The hill hold control system is designed to
assist you in starting to move up hills.
When you start to move up a hill, the sys-
tem helps to prevent the vehicle from roll-
ing
downward
(for
approximately
seconds) while you move your foot from
the brake pedal to the accelerator pedal.
®
WARNING
• Do not rely excessively on the hill
hold control system. The hill hold
control system may not prevent the
vehicle from rolling downward on a
hill under all load or road condi-
tions.
Always
be
prepared
depress the brake pedal to prevent
the vehicle from rolling downward.
Failure
to
pay
attention
depress the brake pedal to hold the
vehicle on a hill when necessary,
may result in loss of control or an
accident.
• The hill hold control system is not
designed to stop the vehicle on a
hill.
(Continued)
OPERATING YOUR VEHICLE
WARNING
(Continued)
• After you release your foot from the
brake pedal, accelerate the vehicle
to move up immediately. If you
release your foot from the brake
pedal over 2 seconds, the hill hold
control system will be canceled. If
so, the vehicle may roll downward,
which can result in an accident
depending on the degree of slope.
2
And, the engine may stall and the
power assist for the steering and
brakes will not work so steering
and braking will be much harder
than usual which can result in an
accident or vehicle damage.
The hill hold control system activates for a
maximum of about 2 seconds if your foot is
moved from the brake pedal when the fol-
lowing conditions are all met.
to
1) The gearshift lever is in a forward gear
or reverse gear.
and
2) The parking brake is released.
3) The vehicle is on an upward incline.
On models equipped with the ENG A-
STOP system, the hill hold control system
is activated when the engine is restarted
after being stopped automatically, even if
the previous conditions are not met.
3-32
57RK0-14E

Advertisement

Table of Contents
loading

Table of Contents