Table of Contents
Advertisement
3.2 Rear connections
Power on/off switch
Power supply socket
RS 232 interface
3.3 Installing the Viscometer
To install your Viscometer:
1. Place the base on a stable and flat
surface.
2. Rotate the adjustable feet under the
base until the instrument is level; use a
bubble level placed on the base of the
instrument as a guide.
3. Remove the plastic drive coupling
protection cap from the bottom of the
Viscometer; pull the cap vertically
down until it is well clear of the drive
coupling and then remove to one side.
Do not dispose of the protection
cap. To prevent accidental damage
to the drive coupling, always replace
the cap when the instrument is not
in use.
4. Connect the instrument to the mains.
Drive
coupling
protection
cap
R
7
Advertisement
Table of Contents
