Configuring Your Viscometer - Elcometer 2250 Operating Instructions Manual

5 CONFIGURING YOUR VISCOMETER

To configure your Elcometer Krebs Viscometer ready to take measurements, do the following:
1. Switch on the Viscometer (use the power on/off switch at rear of head).
The instrument displays:
2. While the welcome message is displayed (5 seconds), press [START] and then [ENTER].
The instrument displays the viscosity units selection screen:
3. If necessary, press [UP] or [DOWN] to select the working units: Ku (Krebs units),
cP (Centipoise) or g (grams).
4. Press [ENTER] to confirm your selection.
The instrument displays the SWT (sample wait time) selection screen:
5. If necessary, press [UP] or [DOWN] to select the sample wait time: minimum = 1 second,
maximum = 99 seconds, default = 1 second.
6. Press [ENTER] to confirm your selection.
The instrument displays the SMT (sample measure time) selection screen:
7. If necessary, press [UP] or [DOWN] to select the sample measure time: minimum = 5 seconds,
maximum = 99 seconds, default = 10 seconds.
10
R
2250 KV 1.1
Viscosity Units
SWT: 01
Sample Wait Time
SMT: 10
Sample Measure Time
Ku