Halting A Program In Progress; Performing A Stand-Alone Drying Cycle - Smeg WD3060 User Manual

7.4

HALTING A PROGRAM IN PROGRESS

To interrupt a program in progress: press STOP.
Once the button is pressed, the program switches to pause state:

The door can only be opened until the temperature is less than 40°C, by pressing ENTER

Restart the cycle within 60 seconds by pressing START.
7.5

PERFORMING A STAND-ALONE DRYING CYCLE

The drying phase is set for every program (except for prewash programs) by default.
To start a "stand-alone" drying phase:

Press "LEFT" from the menu of the selected program.

The drying phase activation screen appears: press ENTER to confirm the start of drying (or press ESC if you prefer to go
back to the previous screen).

Parameters on the display during drying:
o
Phase name
o
TA1: Drying System temperature probe;
o
TT: phase target temperature;
o
RunT: time passed.
At the end of the phase, open the door and wait a few minutes before extracting the instruments, to allow both the well and the
processed material to cool down (the drying phase concludes with a cooling phase).
WD3060 - WD5090
PR: PLASTIC 70°C + Dry
F0 PREWASH
PRELOADING
TL 19.5 TC 19.8
RunT 0:00:20
Fig. 6 - screen of the programming which is running
PR: PLASTIC 70°C + Dry
PROGRAM ENDED
OPEN THE DOOR?
Fig. 7 - "Program ended" screen.
DRYING
Confirm?
Fig. 8 - drying cycle selection screen: Confirm with ENTER.
PR: DRYING
DRYING
TA1 74.5
TT 80.0 RunT 0:00:55
Fig. 9 - screen: drying cycle in progress.
USER MANUAL 15