Interrupting A Program In Execution - Smeg GW0160 Series User Manual

4.10

INTERRUPTING A PROGRAM IN EXECUTION

INTERRUPTING A PROGRAM
A cycle in progress can be interrupted by pressing the Start/Stop button.
During the "Suspension" of the program, the letter "S" appears on the display, followed by the code of
the current program.
For GW0160 - Laboratory Glassware Washer series products, SUSPENSION phase:
1. If the temperature in the chamber is below 40°C: the door can be opened. If the door is closed again within 1
minute, the cycle can be restarted from the phase where it was interrupted. The cycle is always restarted by
holding down the Start/Stop button for 2 seconds.
2. If the temperature in the chamber is above 40°C: a reset cycle is required since the door cannot be opened.
3. If the cycle is interrupted and the user does not press any buttons within 1 minute: the appliance
automatically switches to Reset mode
PROGRAM SPECIAL OPTIONS
4.11
1. Temporary disabling of demi water
2. Delayed start (function introduced from firmware version 4.6.xx.yy).
The "Special Options" menu is accessed by pressing the "Start/Stop" and "Door Opening" buttons simultaneously.
To scroll through the special functions: press the "Functions" button and release at once.
The special options only apply for 1 single cycle, executed after selection of the option. After execution of the cycle,
the default values are restored.
Special options must be confirmed by pressing the "Start/Stop" button; after confirmation, the program display
returns to the screen.
If the option is not confirmed, after 10 seconds without any action the system quits the option and the last parameter
set is maintained.
User manual
fig. 10 – Interrupting a Program: hold down the Start/Stop button
fig. 11 – Display screen, Suspension of program 5: S 05 ".
GW0160 Series Page 26 - 70