How To Conduct A Washing/Disinfecting Cycle - Smeg WD3060 User Manual

7.3

HOW TO CONDUCT A WASHING/DISINFECTING CYCLE

Once the device has been installed, the detergent cans have been connected and the trolleys have been loaded, to
perform a washing cycle:

Power up the device by turning the MASTER SWITCH from "0" to "I" (for devices with side cabinet, the switch is
accessed by opening the cabinet door);

Wait for a moment to allow the system to load: the screen of the last program selected will appear (e.g.
"PLASTIC 70°C");

Press ESC to access the program selection menu;

Use the UP and DOWN keys to choose the program required.

Press ENTER to confirm the program.

Press START to start the selected program.
Once the program has started, the display shows the following information:

the name of the program being run (e.g. "PLAST 70°C");

the current phase and the process being carried out (e.g. "PRELOADING");

TL - the temperature inside the washing chamber;

TC - the control temperature;

RunT - the time since the program started.
The end of the cycle is shown on the display by a specific screen: the cycle has been completed successfully. At the end of the cycle
the user can open the door by pressing ENTER.
Once the door is open, the processed instruments can be unloaded. The device is ready to perform a new washing/disinfection
program.
It is best to wait a few minutes between cycles, with the door of the device open, to allow the washing chamber to
cool, making the next washing cycle more effective.
A low temperature at the start of the washing cycle provides full benefits from the combined action of time and
temperature during the process and the detergent used.
WD3060 - WD5090
fig. 3 – Side cabinet door opening.
< 1 PREWASH >
< 2 DEMI PREWASH >
< 3 PLASTIC 70°C >
< 4 SHORT 60°C >
. . .
Fig. 4 - Program selection screen
PR: PLASTIC 70°C + Dry
(000003)
Phases N.: 5
Duration: 1:10:00
< Drying On >
05/02/2013 08:30:15
Fig. 5 - Screen of the program selected
USER MANUAL 14