General Warnings - Smeg WD3060 User Manual

5

GENERAL WARNINGS

.Leaning or sitting on the open door of the device might cause it to tip over, putting people in danger.
The door is not designed primarily to support loads.
.The maximum weight which can be loaded on the door, including the weight of the instrument trolley,
must never exceed 37kg (if the weight of the instrument trolley and baskets is excluded, the maximum
processable load must never exceed 23kg).
.For optimal DRYING, the load for processing must never exceed 15 kg.
.With use of the device, localised or general discolouring of the heating element may occur. This is normal
since it is due to the operating mode and does not reduce the appliance's effectiveness.
.In the event of malfunction, disconnect the appliance from the electricity supply and turn off the water
tap. Then contact your nearest authorised Service Centre.
.Open the door carefully, first waiting for the wash cycle to end. The appliance has an automatic door
opening system; do not force the door open while a program is in progress.
.The appliance must only be used by staff suitably trained in its operation.
.The chamber of the appliance is not designed for users to climb into it. The user must never climb into the
chamber; this might put his safety at risk (ref. 7.102 IEC61010-2-040:2005).
DEMI WATER ABSENCE
If demineralised water is not available, the user is responsible for ensuring that the quality of the water
supplied to the medical device does not cause mineral salts or other substances to be deposited on the
treated instruments, rendering their subsequent use unsafe.
Do not place flammable substances inside the device. Do not use flammable detergents.
Never place alcohol or solvents such as turpentine, which might cause an explosion, inside the appliance.
Do not place materials dirty with ash, wax or paint inside the appliance.
Never touch the heating element immediately after the end of a wash programme.
Do not touch any residual liquids left inside the washing chamber; scalding hazard (ref. 7.102.c IEC61010-
2-040:2005).
When moving the appliance around, a forklift truck or pallet truck must be used.
Before leaving the factory, the base of the appliance is secured to a pallet, which is used for lifting and
transporting it.
Do not use appliances which have been damaged in transit!
If in doubt, contact your dealer.
Once decommissioned, the appliance must be rendered unusable. Cut the power supply cable after
removing the plug / disconnecting the cable from the power socket.
WD3060 - WD5090 USER MANUAL 9