Remote Oil Filter - Westerbeke 10.0 EGTD Operator's Manual

(OPTIONAL)
REMOTE Oil FILTER (OPTIONAL)
PN.040078
INSTALLATION
This popular accessory is used to relocate the engine's oil fil-
ter from the engine to a more convenient location such as an
engine room bulkhead.
NOTE: Refer to ENGINE OIL CHANGE in this manual for
instructions on removing the oil filter.
APPLY A THIN COAT OF ClEAN Oil TO THE O·RING WHEN
INSTALUNG THIS KIT. THREAD THE KIT ON, THEN HAND
TIGHTEN AN ADDITIONAL3/4 TURN AFTER THE O·RING
CONTACTS THE BASE.
NOTE THE "IN" AND "OUT" MARKINGS
ON THE ADAPTER WHEN THE HOSES ARE
REMOVED FOR INSTAllATION SO THEY
, Will BE RECONNECTED CORRECTLY.
To install, simply remove the engine oil filter and thread on
WESTERBEKE'S remote oil filter kit as shown. Always
install this kit with the oil filter facing down as illustrated.
Contact your WESTERBEKE dealer for more information.
NOTE: Westerbeke is not responsible for engine failure due to
incorrect installation of the Remote Oil Filter.
A
CAUTION:
It is vital to install the oil lines
correctly. If the oil flows in the reverse direction, the
by-pass valve in the niter assembly will prevent the oil
from reaching the engine causing an internal engine
failure. If there is no oil pressure reading, shutdown
immediately and check the hose connections
THE IN CONNECTION HOSE
MUST ATIACH TO THE OUT
CONNECTION AT THE
REMOTE OIL FILTER.
THE OUT CONNECTION HOSE
MUST ATIACH TO THE IN
CONNECTION AT THE
REMOTE Oil FILTER.
Engines & Generators
20
APPLY A THIN COAT OF ClEAN OIL TO THE FIL·
TER GASKET WHEN INSTALUNG. AFTER THE
FILTER CONTACTS THE BASE, TIGHTEN IT AN
ADOITIONAL3/4 TURN.