Remote Oil Filter - Westerbeke 8.0KW - 60Hz EDT Operator's Manual

REMOTE OIL FILTER (OPTIONAL)
PN:040078HEMOTEOILFILTER SET .
INSTALLATION
This popular accessory is used to
reloc~te
the engine's oil fil-
ter from the engine to a more convenient location such' as an
engine room bulkhead.
NOTE: Refer to ENGINE OIL CHANGE in this fI11lnual for
instructions on removing the oil jilter.
APPLY A THIN COAT OF CLEAN OIL TO THE O-RING WHEN
INSTALLING THIS KIT. THREAD THE KIT ON, THEN HAND
TIGHTEN AN ADDITIONAL 3/4 TURN AFTER THE O-RING
CONTACTS THE BASE.
NOTE THE "IN" AND "OUT" MARKINGS
ON THE ADAPTER WHEN THE HOSES ARE
REMOVED FOR INSTALLATION SO THEY
• WILL BE RECONNECTED CORRECTLY.
To instal!, simply remove the engine oil filter and thread on
WES1ERBEKE'S remote oil filter kit as shown. Always
install this kit with the oil filter facing down a. illustrated.
Contact your WES1ERBEKE dealer for more information.
NOTE: Westerbeke
is not responsible for engine failure due to
incorrect installation of the Remote Oil Filter.
A
CAUTION:
It Is vital to Install the oil lines
correctly. If the oil flows in the reverse direction, the
by·pass valve In the filter assembly will prevent the oil
from reaching the engine causing an internal engine
failure. If there is no oil pressure reading, shutdown
immedialety and check the hose connections
IN CONNECTION HOSE
MUST ATTACH TO THE OUT .
CONNECTION AT THE
REMOTE OIL FILTER.
Englnes..~, ~en~,:ators
21
APPLY A THIN COAT OF CLEAN OIL TO THE FIL-
TER GASKET WHEN INSTALLING. AFTER THE
FILTER CONTACTS THE BASE, TIGHTEN IT AN
ADDITIONAL 3/4 TURN.