Westerbeke 10.0 EGTD Operator's Manual page 14

OPTIONAL REMOTE CONTROL PANELS
OPERATING INSTRUCTIONS ,
DESCRIPTION
There are several options available when selecting remote
operation of your generator.
1. Mount a second (repeating) Instrument Control Panel in a
remote location.
2.
Simply remove_ the Instrument Control Panel from the
control box and mount it as a remote panel.
NOTE:
The Instrument Control Panel can be replaced by
installing a basic
start~~top
panel in the control box.
3. Mount a remote start/stop control panel ina remote
location.
Remote panels connect to the 8 pin plug on the back of
the control box using the extension harnesses listed below.
EXTENSION HARNESS
PNit056236 EG DIESEL
(8
PIN) 15FT
PN1t056235 EG DIESEL
(8
PIN) 30FT
INSTRUMENT ·.
CONTROL PANEL(AS A REMOTE PANEL)
PN56246
NOTE: When connecting a remote panel to the plug connector
on the back of the control box. DO NOT discard the plug with
jumper found in this plug connector. Keep it with the
~it.
Attach
it to the rear lifting eye. It will be useful in troubleshootmg a
DC/
running issue by eliminating the remote panel and returning this
plug with jumper to the connector.
REMOTE START/STOP PANEL • DESCRIPTION
The Remote Start/Stop Panel has the same three rocker
switches as the Instrument Control Panel. Their function is
the same. This panel has a RELEASE STARTER LED. This
LED will illuminate when the PREHEAT is depressed. When
this panel is remote mounted, this LED will indicate when
the generator has started. When depressing the START
rocker switch, this LED will dim. When the generator starts,
the LED will brighten. This indicates to release the START
rocker switch. The PREHEAT rocker switch is held
depressed for about 4-5 seconds to allow the oil pressure to
reach 10 psi, then release it.
For the REMOTE START/STOP PANEL wiring diagram
and wiring harness, refer to the Table of Contents.
REMOTE START/STOP PANEL
PN56320
Engines
&
Generators
8