Krone Round Pack 1250 Original Operating Instructions page 95

Single axle - hydraulic brake system
At an oil pressure of ca. 100 bar, the brake lever should be
ca. 55 mm from the plate (2) when in brake position.
This setting can be made at the brake shaft on the
profile:
• Remove Seeger circlip ring (1) and press the brake
shaft as far as possible towards the inside.
• Loosen screw (2).
• Pull off brake lever (3) and set.
• Tighten screw (2).
• Put Seeger circlip ring (1) back on.
Maintenance
2
1
55 mm
max. brake lever
Max. Bremshebelstellung
position at 100 bar
bei 100 bar
1
3
2
Hydraulic air
Hydraul. - Bremse
brake system
RP-00-002
RP-00-003
IX - 11