Clarke Strong Arm CS10PRH Operating & Maintenance Instructions

Clarke Strong Arm CS10PRH Operating & Maintenance Instructions

10 tonne hydraulic pump, ram & hose

Advertisement

Quick Links

10 Tonne Hydraulic Pump, Ram
& Hose
Model No. CS10PRH
PART NO: 7617020
OPERATING & MAINTENANCE
INSTRUCTIONS
GC09/12

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Strong Arm CS10PRH and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Clarke Strong Arm CS10PRH

  • Page 1 10 Tonne Hydraulic Pump, Ram & Hose Model No. CS10PRH PART NO: 7617020 OPERATING & MAINTENANCE INSTRUCTIONS GC09/12...
  • Page 2: Specifications

    Please note that the details and specifications contained herein, are correct at the time of going to print. However, CLARKE International reserve the right to change specifications at any time without prior notice. Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com...
  • Page 3: General Safety Precautions

    Any damage should be properly repaired or the part replaced. If in doubt, DO NOT use. Consult your local Clarke dealer. 10. Store out of the reach of children and do not allow persons unfamiliar with these instructions to use this product.
  • Page 4 ASSEMBLY When assembling the Hydraulic Ram, Pump unit and attachments, unscrew and retain the plastic end plugs on the connections for future use. Ensure the hydraulic hose is tightly screwed to the connection. 1. Screw the Pump Handle into the socket in the pump unit. 2.
  • Page 5: Operation

    OPERATION Assemble the components including a flat base and as many extension tubes as required. NOTE THAT WHEN ADDING FURTHER EXTENSION TUBES, THE MAXIMUM RATED LOAD IS REDUCED. (SEE WARNING LABEL) 1. Connect the Hydraulic Ram or Hydraulic Spreader to the connecting hose using the screw-on hose connector.
  • Page 6: Fault Finding

    5. Aim the pushing end towards the damaged area and slowly apply pressure with the pump. 6. Once contact is established at each end, keep as well clear as practical and slowly apply pressure to the damaged area until the desired correction has been made.
  • Page 7: Maintenance

    The oil level should be near the bottom of the opening. If required, oil can be topped top using Clarke Hydraulic Oil. (part no. 3050830 for 1 litre). After extensive use, the hydraulic oil should be replaced to ensure longer equipment life.
  • Page 8: Component Parts

    COMPONENT PARTS Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com...
  • Page 9 COMPONENT PARTS t l i n i l n i l n i l c i l n i l n i l Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com...
  • Page 10 COMPONENT PARTS HYDRAULIC RAM n i l n i l n i l n i l c i l n i l Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com...
  • Page 11: Declaration Of Conformity

    DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com...

Table of Contents