Advertisement
SAS2010DE Thermostat for Wireless Receiver
SAS2010DE is a wireless non-programmable thermostat designed for hot water
radiant heating systems and electric heating cable system. It is a one to one receiver,
independent circuit with adjustable temperature limiter function .
SPECIFICATION：
Power source ............................................100-240VAC 50/60HZ
Wireless signal frequency...............................868MHZ（ FSK）
Wireless signal effective range ........................100m
Accuracy........................................ ......... ...±1℃
Ambient temperature -Operation .....................0 ~+50
Ambient temperature –transport .......................-10 ~60
The limit temperature value .......................30℃, 40℃, 55℃, Factory default: 40℃
Dimension ...................................................113×83×30mm
IMPORTANT SAFETY INFORMATION:
Always turn off power at the main power source by unscrewing fuse or switching
circuit breaker to the off position before installing, removing, cleaning, or servicing this
thermostat.
Read all of the information in this manual before installing this thermostat.
Only a professional contractor should install this thermostat.
All wiring must conform to local and national building and electrical codes and
ordinances.
This thermostat has a removable fuse to protect the system from damage. If system is
not operating properly, check wiring and replace fuse if necessary.
Use this thermostat only as described in this manual.
MOUNTING THE RECEIVER
1.
Remove the screw from the bottom of thermostat. Gently pull the control panel
straight off the base. Forcing or prying on the thermostat will cause damage to the
unit.
2.
Connect wires beneath terminal screws on power supply module using appropriate
wiring schematic. See figure 5
3.
Push power base into 86mmX86mm conduit box.
4.
Using two mounting screws mount the power base to the wall. Place a level against
bottom of base, adjust until level, and then tighten screws. (Leveling is for
appearance only and will not affect thermostat operation.)
5.
Replace control panel on the power base by snapping it in place
℃
℃
℃
℃
1
Advertisement
Table of Contents
Related Manuals for Saswell SAS2010DE
Summary of Contents for Saswell SAS2010DE
- Page 1 SAS2010DE Thermostat for Wireless Receiver SAS2010DE is a wireless non-programmable thermostat designed for hot water radiant heating systems and electric heating cable system. It is a one to one receiver, independent circuit with adjustable temperature limiter function . SPECIFICATION： Power source ……………………………………..100-240VAC 50/60HZ Wireless signal frequency………………………….868MHZ（...
- Page 2 Panel Base R emove the panel S crews for mounting thermostat to conduit box WIRING DIAGRAM Power:100-240VAC 50/60HZ Figure 5 SWITCH AND LED DESCRIPTION OF RECEIVER Select Button Indicator A (RED / GREEN LED) Indicator B (GREEN LED) Indicator C (YELLOW LED)
- Page 3 CHECK THERMOSTAT OPERATION The description of thermostat working condition： Standby：when power input, all the lights no display Power status：Shortly press the button ,indicator A(red ) turn on as long as there is power to the unit. Shutdown status ：On state, indicator A(red ) is long bright. Shortly press the button, indicator A(red )turn off indicates it is in shutdown status mode, thermostat shut down all output.
- Page 4 Control Centre setting below room temperature. The Control Centre will emit signals to the Receiver asking to turn off the heating device. LED C(yellow) on the Receiver flashes means Receiver has received the signals. LED B(green) turns off means heating device is deactivated.
Need help?
Do you have a question about the SAS2010DE and is the answer not in the manual?
Questions and answers