Adjust Parameter Settings - Rinnai I Series Installation And Operation Manual

1. Locate the PC Board (lower left side of unit) (Figure 3).
2. Locate the red button on the PC Board (Figure 3).
3. Press and hold the red button for five seconds (Figure 3).
Figure 3
PC Board
4. Press the Mode button on the controller.
5. Scroll to parameter
Select button.
6. Press the (Up) or
the appropriate gas type.
A
•
Select for Natural Gas (NG)
•
Select for Propane (LP)
Then, press the Select button.
7. Parameter settings are complete. To enter normal operation mode, press the Mode button.
122
AO
and press the
(Down) arrows to select
01-a
A0-a
NATURAL GAS
A0-a
Rinnai I-Series Condensing Boiler Combi Manual
Press and Hold
Red Button
for Five Seconds
PROPANE
a0-