Trimming Sub Clips - Sony PDW-R1 Operation Manual

5-2-3 Trimming Sub Clips

SET button
THUMBNAIL button
KEY INHI TC COUNTER
ON SEL HOLD
INT PRESET F-RUN
NETWORK
LOCAL EXT
ACCESS REMOTE
RP188 REGEN R-RUN
OFF
ALL/CH-1 CH-2 CH-3 CH-4
METER MONITOR
VARIABLE
SEL SEL
REC
PRESET
PB
L/ST/R
AUDIO
PREV PLAY NEXT STOP REC
TOP F REV F FWD END
G/IN button
NEXT button
PREV button
1
Carry out steps 1 to 4 of 5-2-2 "Reordering Sub Clips"
to select a sub clip and display the sub clip operation
menu.
2
Use the F or f button to select TRIM, and then press
the SET button.
The first frame of the selected sub clip appears. The
first and last frames are set as provisional In and Out
points, and the IN and OUT indicators light.
In this state, you can play back and search the entire
disc.
To cancel the trim and return to the previous
screen
With the SHIFT button held down, press the SET
button.
3
Play back and search the disc to find scenes to set new
In and Out points.
SHIFT button
RESET button
SHUTTLE JOG
SUB THUMB
CLIP NAIL SHIFT
CLIP ESSENCE
MENU
MARK
MENU SET RESET
SYSTEM S.SEL
MENU
MARK1
IN OUT
MARK2
Jog dial
g/OUT button
F/f buttons
4
At the scene where you want to set a new In or Out
point, hold down the G/IN button (to change the In
point) or the g/OUT button (to change the Out point)
and press the SET button.
Depending on the button that you pressed, a new In or
Out point is set.
To change both the In and Out points
Carry out steps 3 and 4 for both the In and Out points.
To reset the In or Out point
With the G/IN button or g/OUT button held down,
press the RESET button. The In or Out point is
restored to the value it had before the sub clip trim
screen opened.
To cue up the In or Out point
With the G/IN button held down, press the PREV
button. Or with the the g/OUT button held down, press
the NEXT button.
Note Note
You can escape from the sub clip trim screen to full-
screen display without executing a trim if you press the
THUMBNAIL button.
5
Once you have set the new In point or Out point, hold
down the SHIFT button and press the SET button.
The trim is executed, and you return to the sub clip
thumbnail display.
To cancel the trim
Reset the In or Out point to the value it had before you
entered the sub clip trim screen, and then hold down
the SHIFT button and press the SET button.
6
Save the current clip list to disc.
See 5-2-6 "Saving the Current Clip List to Disc" (page
66).
65
5-2 Creating Clip Lists