Maintenance Menu; Items In The Maintenance Menu - Sony PDW-R1 Operation Manual

7-4 Maintenance Menu

7-4-1 Items in the Maintenance Menu

The following tables show the items in the maintenance
menu.
• Item names are the names which appear in the video
panel, and on an external monitor to which the output of
the VIDEO OUT 2 (SUPER)/SDI OUT (SUPER)
connector is input.
• The values in the Settings columns are the values which
appear in the time data display section. (The values may
Item
METR HEAD ROOM
DATA LENGTH
NON-AUDIO INPUT
Sub-item
tr1/tr2
tr3/tr4
tr5/tr6
tr7/tr8
INPUT LEVEL
Sub-item
CH1/CH3
CH2/CH4
OUTPUT LEVEL
Item
DHCP
IP ADDRESS PRESET
112
7-4 Maintenance Menu
AUDIO CONFIG: items relating to audio control
Setting
Select the audio reference level (headroom).
–12dB,–16dB, –18dB, –20dB (525(U)/525(J) line modes)
–12dB, –16dB, –18dB, –20dB, EBUL (625 line mode)
When "IMX50," "IMX40," or "IMX30" is selected in setup menu item 031, this selects the
audio quantization bit count and number of recording channels.
16×8 (16bit × 8ch): 16 bits × 8 channels
24×4 (24bit × 4ch): 24 bits × 4 channels
Note
When item 031 is set to "DVCAM," the setting is automatically fixed at 16 bits × 4 channels.
Select whether to handle digital audio signals as non-audio signals during recording.
Audio (audio): Handle as audio signals.
data: Handle as non-audio signals.
Set the upper limit for the signal level input to audio channels 1/3 or 2/4.
+4dB, 0dB, –3dB, –6dB (525(U)/525(J) line modes)
+4dB, 0dB, –3dB, –6dB, EBUL (625 line mode)
Set the reference level for audio output signals.
+4dB, 0dB, –3dB, –6dB (525(U)/525(J) line modes)
+4dB, 0dB, –3dB, –6dB, EBUL (625 line mode)
NETWORK CONFIG: items relating to network settings
Setting
Set whether to assign an IP address automatically with the DHCP server.
DISABLE: Do not assign automatically.
ENABLE: Assign automatically.
Set IP address.
192.168.001.010
Note
When DHCP is set to "ENABLE," it is not possible to set the IP address.
appear in a different format in the video panel and on an
external monitor. In this case, the video panel values are
shown in parentheses.) Underlined values are the factory
defaults.
For information about the DRIVE MAINTENANCE,
ADJUST, CHECK, BATTERY CONFIG and SERVICE
SUPPORT items, refer to the Maintenance Manual.