Sony PDW-R1 Operation Manual page 123

When the unit is powered on
Message in time Display
data display
condition
MENU Ver.UP on, limit, off
ILL. SETUP! on, limit, off
Exchg batt! on, limit, off
LOW BATT! on, limit, off
BATT EMPTY! on, limit, off
a) With respect to setting of basic menu item 016
When a disc is inserted
Message in time Display
data display
condition
Unknown FS! on, limit, off
No FS! on, limit, off
ILL. Disc! on, limit, off
Salvage NG on, limit, off
525/60 Clip on, limit
625/50 Clip on, limit
IMX50 Clip on, limit
IMX40 Clip
IMX30 Clip
DVCAM Clip
Description
a)
Setup menu settings were reset,
because this unit was upgraded.
Setup menu data is invalid, or data
recalled with the maintenance menu
item "SETUP MAINTENANCE" –
"AUTO BANK RECALL" is invalid.
NVRAM battery is exhausted.
Battery pack power is low.
Battery pack power is exhausted.
Description
a)
The loaded disc was formatted by an
unknown file system.
The file system cannot be detected.
An unsupported disc was inserted.
Recovery of disc contents (salvage)
failed.
A disc recorded in NTSC format was
inserted when this unit is in 625 line
mode (PAL system).
A disc recorded in PAL format was
inserted when this unit is in 525(U) or
525(J) line mode (NTSC system).
The recording format of the loaded disc
differs from the format specified with
basic menu item 031 "RECORDING
FORMAT."
Action
Reset the setup menu items.
See 7-2-2 "Basic Menu Operations" (page
94) and 7-3-2 "Extended Menu Operations"
(page 108) for information about making
setup menu settings.
Maintenance menu item "SETUP
MAINTENANCE" - "SAVE MENU DATA/
LOAD MENU DATA" (see page 113) can be
used to temporarily back up and restore the
current menu settings.
Reset the items in the setup menu.
It is time to exchange the battery on the
board. Contact your Sony service
representative.
Exchange with a charged battery pack.
See 3-2-3 "Using a Battery Pack" (page 33)
for more information about exchanging
battery packs.
Action
Eject or format the disc.
See 3-6-5 "Formatting a Disc" (page 39) for
more information about formatting.
Eject the disc.
See 3-6-7 "Handling of Discs When
Recording Does Not End Normally
(Salvage Function)" (page 40).
Use a disc recorded with the PAL system.
Use a disc recorded with the NTSC
system.
To record on the disc, change the setting of
basic menu item 031.
See 7-2-2 "Basic Menu Operations" (page
94) about how to change this setting.
123
8-4 Alarms